|
|
TM 10-3930-660-24-1
TRANSMISSION TEMPERATURE SENDER REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
References
Tools and Special Tools
TM 10-3930-660-10
Tool kit, general mechanic's (Item 39, WP 0324 00)
Shop equipment, common no. 1 (Item 20, WP 0324
Equipment Condition
Battery cables disconnected (WP 0107 00)
Materials/Parts
Transmission cover removed (WP 0150 00)
Sealant, Loctite (Item 43, WP 0323 00)
Lockwasher (2)
NOTE
The transmission temperature sender is located on the left side of the transmission.
REMOVAL
1.
Remove nut (1), lockwasher (2) and disconnect lead
(3) from sender (4). Discard lockwasher.
2.
Remove sender (4) from elbow (5).
3.
If necessary, remove elbow (5) from transmission (6).
INSTALLATION
1
2
1.
If necessary, install elbow (5) to transmission (6).
3
NOTE
4
5
Apply loctite to threads of sender.
2.
Install sender (4) into elbow (5).
6
3.
Install lead (3), new lockwasher (2) and nut (1), onto
sender (4).
4.
Connect battery cables (WP 0107 00).
5.
Install transmission cover (WP 0150 00).
409-369
6.
Run engine and check for proper operation and leaks
(TM 10-3930-660-10).
END OF WORK PACKAGE
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |