 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-1
FORK AUTO LEVELER SWITCH MAINTENANCE - CONTINUED
0080 00
INSTALLATION - CONTINUED
4.
Carefully position auto leveler cable (4) and grommet
(30) through notch in switch cover (26). If removed,
install conduit (31) to auto leveler cable (4).
5.
Position switch cover (26) on carriage assembly (3)
and secure with two new lockwashers (29), two cap-
13,14
screws (28), two retainer nuts (27), two new lock-
washers (25) and two bolts (24).
2
6.
If removed, install cable clamp (21) to auto leveler
cable (4). Install, but do not tighten, capscrew (19) and
new lockwasher (20).
15
7.
Slide conduit (31) on auto leveler cable (4) so it is
positioned between cable clamp (21) and cable grom-
16
met (30).
18
4
8.
Route auto leveler cable (4) through cable clamp (21)
17
and pull cable tight from top. Tighten capscrew (19)
and new lockwasher (20) to secure cable clamp and
autoleveler cable to clamp halves (22).
19,20,21
9.
Pull auto leveler cable (4) tight from top and secure
auto leveler cable to tube of fork tilt cylinder (18) with
22
new tie down straps (15 thru 17).
409-303
10.
Secure auto leveler cable (4) to MLRS attachment
valve cables (14) with two new tie down straps (13).
NOTE
Any slack in auto leveler cable must be located at boom electrical box end of cable.
11.
Install MLRS attachment valve cover (8).
12.
Secure cover (8) with two capscrews (10), two new
10,11
lockwashers (11) and two nuts (12).
13.
Plug two male plugs of vehicle wiring harness into
8
two female plugs of light (9) as tagged.
12
9
409-301
0080 00-5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals