 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-1
FORK AUTO LEVELER SWITCH MAINTENANCE - CONTINUED
0080 00
INSTALLATION - CONTINUED
5
14.
Insert plug on auto leveler cable (4) into connector (7)
on boom electrical box (5). Turn collar (6) until cable
is secure.
4
6,7
409-300
15.
Connect battery cables (WP 0107 00).
Adjust fork auto leveler switch (1). See Adjustment in this work package.
16.
ADJUSTMENT
1.
Remove switch cover from carriage assembly.
2.
Start engine (TM 10-3930-660-10).
3.
Turn on fork auto leveler control in cab.
4.
Raise forks approximately 2 ft (61 cm) above ground.
5.
Place level on forks and note level reading.
1
NOTE
23
23
Level reading should be within +/- 2 degrees of
0 if switch is properly adjusted. If necessary,
refer to step 6 to adjust switch.
6.
Turn three adjustment nuts (23) on switch (1), as
required until 0 degree reading is obtained on level.
7.
Turn off fork auto leveler control in cab and manually
tilt carriage assembly up or down.
409-302
8.
Turn on fork auto leveler control in cab and note level
reading after forks have leveled.
NOTE
Reading will be within +/- 2 degrees of 0 if switch is properly adjusted.
9.
If necessary, repeat steps 6 thru 8, as required until switch (1) is properly adjusted.
10.
Stop engine (TM 10-3930-660-10).
11.
Install switch cover to carriage assembly.
END OF WORK PACKAGE
0080 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals