 |
|||
|
|
|||
|
Page Title:
INTAKE MANIFOLD COVER REPLACEMENT |
|
||
| ||||||||||
|
|
 TM 10-3930-660-24-1
INTAKE MANIFOLD COVER REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Equipment Condition
Tools and Special Tools
High pressure fuel lines removed (WP 0034 00 or
Tool kit, general mechanic's (Item 39, WP 0324 00)
Shop equipment, common no. 1 (Item 20, WP 0324
Ether start hose disconnected (WP 0044 00)
Air inlet pipe removed (WP 0028 00 or WP 0029
Materials/Parts
Sealant, Loctite (Item 48, WP 0323 00)
Gasket (4)
REMOVAL
1
NOTE
2
Two of the fourteen capscrews may be
4
removed with fuel injection lines.
3
1.
Remove fourteen capscrews (1) holding manifold
cover (2) to engine (3).
2.
Remove manifold cover (2) and gasket (4). Discard
gasket.
INSTALLATION
1.
Clean gasket sealing surface on engine (3).
2.
Position new gasket (4) on engine (3).
409-155
3.
Position intake manifold cover (2) on engine (3).
CAUTION
Some of the capscrew holes are drilled through and must be sealed. Apply loctite to the capscrews.
4.
Install twelve capscrews (1) and tighten to 6 lb-ft (8 Nm).
5.
Install air inlet pipe (WP 0028 00 or WP 0029 00).
6.
Connect ether start hose (WP 0044 00).
7.
Install high pressure fuel lines (WP 0034 00 or WP 0035 00).
END OF WORK PACKAGE
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals