 |
|||
|
|
|||
|
Page Title:
Figure 5-136. Power Steering Pump |
|
||
| ||||||||||
|
|
 25.
O-ring
17.
Idler gear assembly
9.
Heat shield
1.
Pump assembly
26.
O-ring
18.
Valve spring
10.
Wear plate
2.
Shaft seal
27.
Relief valve assembly
19.
Valve
3.
Cover bolt, washer
11.
Seal
28.
O-ring
20.
Valve seat
12.
Gear housing
4.
Cover bolt, washer
29.
Cover plug
21.
Retainer
13.
Key
5.
Cover
O-ring
22.
Flow control valve assy.
30.
6.
14.
Retainer
Dowel
31.
Cover assembly
23.
O-ring
7.
15.
Snap ring
v-seal
32.
Wear plate
24.
O-ring
16.
Drive gear
8.
Gasket
Figure 5-136. Power Steering Pump
i n good condition and that the centering spring
on control ball stud end of valve spool. Install
remains aligned between the two retaining washers.
s p o o l in bore from the control ball stud end to
Back nut off one flat (1/6 turn, or 60 degrees).
avoid O-ring interference during assembly.
d. Start control ball stud sleeve plug in control
c. Install washer, spacer, centering spring, washer,
ball stud sleeve.
control ball stud sleeve, capscrew washer and
e. Slide the control ball stud housing over the
capscrew. Install self-locking nut and tighten until
ball stud sleeve.
play between parts is removed. Be sure that nut is
5-90
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals