|
|
STEP 34. The beveled end of the distributor
sleeve must face the input shaft bearing.
STEP 35. Insert the input shaft from the con-
Step 34. Plate 10332
verter end, making sure index splines on shaft are
lined up with index splines in clutch pack.
STEP 36. Carefully tap the input shaft down
using a soft rawhide hammer, until index shaft is
driven from the transmission assembly, continue
to drive shaft down until shaft is seated into
position.
STEP 37. Install the stator support assembly
and fasteners. Remove the clutch pack instal-
l a t i o n tool.
Step 37. Plate 10358
Step 35 - 36. Plate 10357
5-80X
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |