REASSEMBLY - TM-10-3930-644-14-P0302

TM 10-3930-644-14&P

2. To disassemble the cross assembly, break the

D. REASSEMBLY

connecting strap which holds the bearings on

the cross assembly. These straps need not be

Reassemble the cross assemblies to the drive shaft (Fig

replaced.

1-1) or the center plate (Fig 1-2). Install the mounting

capscrews and tighten them to a torque of 25-30 lb-ft

3. Inspect the bearings and bearing surfaces for

CRY THREADS, or 20-24 lb-ft LUBRICATED

evidence of extreme wear or damage. Replace

THREADS.

the cross assembly if any parts are worn or

damaged.

E. INSTALLATION

4. Pack the bearings thoroughly with a high melting

1. Position output flange on transmission shaft or in

point wheel bearing or universal joint grease.

the transmission internally splined output drive.

Make certain the grease fully covers all bearing

surfaces.

2. Position the differential end of the universal joint

so the holes in the cross assembly align with the

5. Inspec t the output flange splines for wear or

holes in

damage; replace if necessary.

3-132