INSTALLATION (cont) - TM-10-3930-638-24-P0829

TM 10-3930-638-24&P

4-2. ENGINE MAINTENANCE (cont)

f. Pistons and Connecting Rods (cont).

REMARKS

ITEM

ACTION

LOCATION

STEP

INSTALLATION (cont)

NOTE

(cont)

In following step, be sure number on connecting rod cap (2) matches

number on connecting rod (3).

c. Connecting rod cap

Position

(2) and bearing

liner (12)

d. Two connecting

Install and

Tighten to 45-50 pounds foot torque, then

remove

rod nuts (1)

e. Connecting rod

Remove

cap (2)

f. Plasti gage

Measure

Flattened plasti gage located on bearing

liner (12) or crankshaft connecting rod

journal. Clearance shall be between

0.0010 to 0.0040 inch. Install undersize

bearing liner kit and regrind crankshaft

journals (para 4-2d) if clearance exceeds

0.0040 inch

Lubricate

Use No. 30 oil

g. Crankshaft con-

netting rod

journals

h. Connecting rod

Use No. 30 oil; be sure numbers on caps (2)

Lubricate and

cap (2), bearing

position cap

and connecting rod (3) match

liners (12)

i. Two connecting

Install

Tighten to 45-50 pounds foot torque

rod nuts (1)

Cylinder block,

Installed in step 4C of removal

Cylinder liner re-

Remove

top

taining cap screws

and washers

4-51