Rotation Cylinder Assembly (cont). - TM-10-3930-638-24-P0743

TM 10-3930-638-24&P

3-30. DRAULIC LIFT SYSTEM MAINTENANCE (cont)

d. Rotation Cylinder Assembly (cont).

ITEM

REMARKS

ACTION

STEP

LOCATION

DISASSEMBLY (cont)

NOTE

Perform following steps only if inspection indicates replacement

of bushings (26 and 29) is necessary.

a. Two retaining rings

Remove

Rod (24)

(25)

Use 1-5/8 inches diameter sleeve

Remove

b. Bushing (26)

a. Two retaining rings

Remove

Cylinder (27)

(28)

Use 1-5/8 inches diameter sleeve

b. Bushing (29)

Remove

CLEANING

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and

flammable. Wear protective goggles and gloves and use only in a

well ventilated area. Avoid contact with skin, eyes, and clothes

and don't breathe vapors. Do not use near open flame or exces-

sive heat and don't smoke when using it. Failure to do so could

cause serious injury. If you become dizzy while using cleaning

solvent, get fresh air immediately, and get medical attention. If

contact with skin or clothes is made, flush with large amounts of

water. If contact with eyes is made, wash eyes with water immedi-

ately, and obtain medical aid immediately.

WARNING

Wear safety glasses when drying parts with compressed air. Fail-

ure to do so could cause serious injury to eyes and possible blind-

ness. If you hurt your eyes or if a foreign object is blown into

your eyes, seek medical attention immediately.

Use cleaning solvent P-D-680; dry with

All parts

Clean

compressed air

INSPECTION/REPAIR

Replace if bent, deeply grooved, or scored.

Rod (24)

Inspect

Remove nicks or scratches with medium

grit emery cloth polishing with a rotary

motion

3-235