 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-638-24&P
a. Front Wiring Harness
a. Removal
This task covers
b, Installation
INITIAL SETUP
TOOLS
NSN 4910-00-754-0654
No. 1 Common Organiza-
tional Maintenance Tool Kit
EQUIPMENT CONDITION
MATERIALS/PARTS
Condition Description
Paragraph
Front wiring harness
Engine off.
Tie strap
Battery ground cable disconnected.
Front wiring harness connector
disconnected.
Noise baffle mat rod removed and mat
pulled up and over instrument panel
for access to bottom of instrument
panel.
REMARKS
ACTION
ITEM
LOCATION
STEP
REMOVAL
Tag terminals of all electrical components
Tag and
All harness connectors
Instrument
and disconnect harness leads
disconnect
panel bottom,
stop light switch,
and ROPS posts
Cut and remove from harness and hydrau-
Cut and discard
a. Four tie straps (1)
Rear of trans-
lic return hose
mission
Turn counterclockwise and remove from
Remove
b. Connector nut (20)
harness connector and bracket
and washer (21)
Cut and remove from harness to stop light
Cut and
Two tie straps (2)
Brake tube
switch and brake tube
discard
under floor
Cut and remove from loops in harness wire
Cut and
Two tie straps (3)
Harness loops
discard
at 6 and 10
ampere circuit
breakers, bot-
tom of instru-
ment panel
From clamps (7) and instrument panel
Remove
a. Three nuts (4),
Instrument
lock washers
panel rear
(5), and cap screws
and right
(6)
hand side
From harness
Spread and
b. Clamps (7)
panel
remove
3-117
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals