REMOVAL - TM-10-3930-638-24-P0622

TM 10-3930-638-24&P

3-14. INSTRUMENT PANEL REPLACEMENT (cont)

REMARKS

ITEM

ACTION

STEP

LOCATION

REMOVAL

Loosen and

a. Four nuts (1), lock

Operator's

remove

washers (2) and

compartment

washers (3)

Lift and

b. Four cap screws

remove

(4)

Use sling and hoist

c. Instrument panel

Lift and

remove

(5)

WARNING

CLEANING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and

flammable. Wear protective goggles and gloves and use only in a

well ventilated area. Avoid contact with skin, eyes, and clothes

and don't breathe vapors. Do not use near open flame or exces-

sive heat and don't smoke when using it. Failure to do so could

cause serious injury. If you become dizzy while using cleaning

solvent, get fresh air immediately, and get medical attention. If

con tact with skin or clothes is made, flush with large amounts of

water. If contact with eyes is made, wash eyes with water immedi-

ately, and obtain medical aid immediately.

Wear safety glasses when drying parts with compressed air. Fail-

ure to do so could cause serious injury to eyes and possible blind-

ness. If you hurt your eyes or if a foreign object is blown into

your eyes, seek medical attention immediately.

All parts

Clean

Use cleaning solvent P-D-680. Dry thor-

oughly with compressed air

INSPECTION

Nuts (1), washers (2

Inspect

Replace if worn, or if threads damaged

and 3) and cap

screws (4)

Inspect

Instrument panel (5)

Repair broken welds or cracks by welding.

Replace if severely cracked or damaged

INSTALLATION

Position

a. Instrument

In operator's compartment, with frame

Operator's

and instrument panel mounting holes

panel (5)

compartment

aligned

Install and

b. Four cap screws (4)

Until instrument panel is securely mounted

tighten

washers (3), lock

washers (2) and

nuts (1)

3-116