REASSEMBLY (cont) - TM-10-3930-638-24-P0618

TM 10-3930-638-24&P

3-13. STARTER AND SOLENOID REPAIR (cont)

ACTION

REMARKS

ITEM

LOCATION

STEP

REASSEMBLY (cont)

Lubricate and

End frame

a. Wick (6)

Saturate with engine oil before installing

install

Install

b. Pipe plug (5)

Drive hous-

a. End frame (4)

Lubricate and

Apply light coat of lubricant to frame

ing (53)

position

bushing; then slide on armature shaft

and push against field frame (7)

Install and

b. Two through bolts

Until end frame (4) is securely mounted

(3)

tighten

c. Field coil con-

Wrap with electrical tape

Insulate

nector (2)

d. Starter and sole-

Connect

To test circuit as shown

noid

CAUTION

Check pinion clearance quickly to avoid overheating and damag-

ing solenoid windings.

e. Jumper lead

Momentarily con-

From solenoid M terminal to starter case

nect

(to shift pinion into cranking position)

3-112