 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-638-24&P
3-13. STARTER AND SOLENOID REPAIR (cont)
REMARKS
ACTION
ITEM
LOCATION
STEP
ASSEMBLY (cont)
5
Push clutch back as far as possible toward
Check
f. Drive assembly (15)
(cont)
armature, and check clearance as shown
clearance
pinion
NOTE
Pinion clearance must measure between
0.010 and 0.140 inch to prevent buttons
on the shift lever yoke (30) from rub-
bing on the clutch collar during crank-
ing. If clearance does not fall within
limits, recheck for proper assembly and
replace all worn parts.
From pinion clearance test set-up
Disconnect
g. Starter and
solenoid
On M terminal of solenoid switch (24)
Remove tape
h. Field coil con-
and position
nector (2)
Until field coil connector (2) is securely
Install and
i. Screw (1)
mounted
tighten
3-113
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals