|
|
TM 10-3930-638-24&P
2-42. PARKING BRAKE MAINTENANCE (cont)
a. Parking Brake Linkage (cont).
STEP
ITEM
REMARKS
LOCATION
ACTION
REMOVAL (cont)
NOTE
Don't perform following step unless bracket (27) requires
replacement.
Transmission,
6
a. Two cap screws (25)
Remove
left side, above
and six washers (26)
parking brake
b. Bracket (27)
Remove
CLEANING
7
Parking brake cable (8)
Clean
Use clean diesel fuel
WARNING
Dry cleaning solvent (P-D-680), used to clean parts is toxic and
flammable. Wear protective goggles and gloves and use only in a
well ventilated area. Avoid contact with skin, eyes, and clothes
and don't breathe vapors. Do not use near open flame or exces-
sive heat and don't smoke when using it. Failure to do so could
cause serious injury. If you become dizzy while using cleaning
solvent, get fresh air immediately, and get medical attention. If
contact with skin or clothes is made, flush with large amounts of
water. If contact with eyes is made, wash eyes with water immedi-
ately, and obtain medical aid immediately.
8
All other parts
Clean
Use cleaning solvent P-D-680
inspection/REPAIR
9
Inspect
Replace if dented, bent, or lever action is
Parking brake lever (4)
rough
10
Parking brake cable (8)
Inspect
Replace if clevis mounting holes elongated,
or if cable kinked or threads damaged
11
Inspect
All other parts
Replace if damaged, worn, bent, distorted,
or threads damaged
INSTALLATION/REPLACEMENT
12
Transmission,
Position
On transmission rear cover
a. Bracket (27)
left side, above
b. Six washers (26) and
Place three washers (26) on cap screw (25);
Install
parking brake
two cap screws (25)
tighten to 37-41 pounds foot torque
2-273
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |