 |
|||
|
|
|||
|
Page Title:
Battery Cables and Batteries (cont). |
|
||
| ||||||||||
|
|
 TM 10-3930-638-24&P
2-33. BATTERY SYSTEM MAINTENANCE (cont)
b. Battery Cables and Batteries (cont).
ITEM
ACTION
REMARKS
STEP
LOCATION
CLEANING (cont)
Use clean water on exterior only
Batteries (6)
Clean
4
Use a wire brush or crocus cloth to
Battery posts and cable
Clean
5
remove deposits
clamps (1, 2 and 3)
Use cleaning solvent P-D-680 on
6
Cable terminals (7 and 8) Clean
terminals only
INSPECTION
Replace if worn, or corroded, or if threads
7
All hardware
Inspect
damaged
Replace if insulation frayed, conductors
Battery cables
Inspect
8
broken, or clamps and terminals
damaged
Replace if case cracked or posts damaged
9
Batteries (6)
Inspect
Replace if cracked or corroded
Hold-down straps (5)
Inspect
10
Replace if worn or deteriorated
Grommet (13)
Inspect
11
INSTALLATION/REPLACEMENT
12
Battery compart- a. Two grommets (13)
Install
Position
b. Cables (1 and 3)
ment, rear of
Connect to starter on solenoid B terminal
vehicle
c. Cable terminals (7
Install
and 8)
Around harness and battery cables
d. Clamp (12)
Position
Until clamp (12) is securely mounted
e. Cap screw (11), lock
Install and
tighten
washer (10) and
nut (9)
Lower into battery compartment with
f. Two batteries (6)
Install
posts positioned as shown
g. Two hold-down
On batteries (6)
Position
straps (5)
CAUTION
Do not over-tighten cap screws (4). Excessive tightening will
deform battery case and damage battery.
Until strap (5) is snug against top of
h. Two cap screw (4)
Install and
battery
tighten
i. Cable clamps (2 and 3) Install
Position clamp over battery post and
tighten clamp nut
j. Ground cable clamp (1) Install
Position clamp over negative battery post
and tighten clamp nut
2-186
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals