Starter

TM 10-3930-638-24&P

2-27. STARTING SYSTEM MAINTENANCE (cont)

a. Starter (cont).

REMARKS

ITEM

ACTION

LOCATION

STEP

REMOVAL

Engine compart-

a. Nut (1), lock washer

From solenoid switch S terminal

Remove

ment rear, left

(2) and wire (3)

b. Nut (4), lock washer

Remove

side of vehicle

From solenoid switch B terminal

(5), two cables (6 and

7) and wire (8)

c. Three cap screws (9),

Remove

Support starter (12)

lock washers (10) and

ground cable (11)

d. Starter (12)

Remove

From engine

CLEANING

Starter (12)

Wipe exterior with clean, dry cloth

Clean

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and

flammable. Wear protective goggles and gloves and use only in a

well ventilated area. Avoid contact with skin, eyes, and clothes

and don't breathe vapors. Do not use near open flame or

excessive heat and don't smoke when using it. Failure to do so

could cause serious injury. If you become dizzy while using

cleaning solvent, get fresh air immediately, and get medical

attention. If contact with skin or clothes is made, flush with large

amounts of water. If contact with eyes is made, wash eyes with

water immediately, and obtain medical aid immediately.

Wires (3 and 8) and

Use cleaning solvent P-D-680 on

Clean

cables (6, 7 and 11)

connectors only

WARNING

Wear safety glasses when drying parts with compressed air.

Failure to do so could cause serious injury to eyes and possible

blindness. If you hurt your eyes or if a foreign object is blown

into your eyes, seek medical attention immediately.

All hardware

Use cleaning solvent P-D-680.

Clean

Dry thoroughly with compressed air

INSPECTION

Replace if worn, or if threads damaged

All hardware

Inspect

Replace if insulation frayed, or if

Wires (3 and 8) and

Inspect

conductors broken

cables (6, 7 and 11)

2-120