Starter and Solenoid - TM-10-3930-634-120059

TM 10-3930-634-12

4-37. Starter and Solenoid

a. Removal. Remove left engine side panel. Refer to

figure 4-23 and remove three mounting screws to

remove starter and solenoid.

b. Cleaning and Inspection.

(1) Clean the starter and solenoid with an ap-

proved cleaning solvent and dry thoroughly.

(2) Inspect the starter mounting hardware and

housing for cracks and breaks. Inspect wiring for cuts

and deterioration. Inspect for corrosion.

c. Installation. Refer to figure 4-23 and install three

mounting screws to install the starter and solenoid.

NOTE: REMOVE NUT (4) AND SCREW (8)

THAT SEECURE VOLTAGE REGULATOR

ND BRACKET TO CYLINDER BLOCK.

TA031861

Figure 4-22. Voltage regulator and bracket, removal

and installation.