Cleaning and Inspection. - TM-10-3930-632-120077

TM 10-3930-632-12

Figure 4-35. Accelerator Pedal and Linkage

WARNING

c. Reassembly and Installation. Reassemble

and install the accelerator pedal and linkage as shown in

Dry cleaning solvent, P-D-680, used to

figure 4-35. Adjust the linkage as follows:

clean parts potentially dangerous to

(1) Adjust the position of the clevis on the

personnel and property. Avoid repeated

governor throttle rod as directed in paragraph 4-49.

and prolonged skin contact. Do not use

Make sure the governor arm travels its full length when

near open flame or excessive heat. Flash

the accelerator pedal is depressed. Adjust the position

point of solvent is 100F.-138F. (38C.-

of the clevis on the bellcrank, if necessary, and tighten

60C.).

b. Cleaning and Inspection.

the locknut.

(2) Adjust the position of the stop bolt

(1) Clean all parts except the pedal with

under the accelerator pedal so that the bolt stops pedal

dry cleaning solvent P-D-680; dry thoroughly.

travel as the governor reaches its limit of travel. This

(2)

Inspect the accelerator pedal for

prevents excessive strain on the linkage. Make sure the

cracks, worn pedal surface, worn pivot holes, distortion,

bolt does not limit the travel of the governor arm.

and other damage. Replace a damaged pedal.

(3)

Recheck that all adjustment

(3) Inspect the return spring for cracks,

requirements in paragraph 4-49 are met.

distortion, loss of tension, and worn ring ends. Replace

(4) Replace all worn or damaged parts

a damaged spring.

with new parts.

(4) Inspect all other parts for cracks,

distortion, worn or damaged pivot points, damaged

threads, and other damage; replace damaged parts.

4-49