 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-630-34
TA067495
1
Retaining ring
7
packing
13
Screw
19
Clutch piston
2
Screw
8
Packing
14
Lock plate
20
Reverse
3
Lock plate
9
Roller bearing
15
Retaining ring
21
Pin
4
place bolt
10
Clutch piston
16
Rear cylinder
22
Pressure plate
5
Front cylinder
11
Forward disc
17
Packing
23
Roller bearing
6
Turbine shaft
22
Return spring
18
Packing
Figure 12-12. Forward and reverse clutch, disassembly and reassembly.
(57). Make certain output shaft is installed with internal
Install idler pin (44) and secure retainer to case with
splines toward rear of transmission case. (b) Install new
screws and lock washers (43).
oil seal (55), new gasket (54) and retainer (53) and
NOTE
secure with screws (52).
Make certain the machined reliefs in
NOTE
the idler shaft retainer are positioned
When installing the bearing retainers
down so that the oil in the cap will
on all shafts he certain to align
drain into the case.
match
marks
made
during
(4) Install reverse gear and shaft:
disassembly.
(a) Position reverse gear (42) in the
(3) Install idler gear and shaft:
tranmission case and install shaft (37) with bearings and
(a) Position idler gear (51) in gear box
retaining rings assembled.
and install thrust washer (47) and shaft (48) into idler
(b) Install retaining rings (33 and 39) and
gear (51).
make
certain
they
are
properly
seated.
(b) Install new gasket (46) and retainer
(45).
12-10
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals