Section II. TRANSMISSION CONTROL VALVE

TM 10-3930-630-34

Section II. TRANSMISSION CONTROL VALVE

(2) Refer to figure 12-4 and disconnect the

12-5. Description

control linkage at the control valve.

a. The control valve is mounted on the

(3) Refer to figure 12-4 and disconnect tube

transmission housing and forms the top closure of the

assembly from the control valve. Cap tube assembly to

transmission case.

prevent entrance of foreign matter.

b. Machined porting plates are attached to the

(4) Refer to figure 12-4 and remove control

bottom of the valve to eliminate external piping.

valve mounting screws and remove control valve.

Passages in the plates align with passages drilled or

Remove and discard gasket. Place a clean covering

cast into the transmission housing.

over exposed area of transmission to prevent

12-6. Transmission Control Valve, Removal and

b. Disassembly. Disassemble the transmission

Disassembly

control valve in numerical sequence as illustrated in

a. Removal.

(1) Refer to TM 10-3930-630-12 and remove

floor and toe plates.

TA067487

Figure 12-4. Transmission control valve, removal and installation.

12-4