Figure 2-8. Flywheel housing timing cover, removal and inspection

TM 10-3930-630-34

TA067380

Figure 2-8. Flywheel housing timing cover, removal and

installation.

c. Remove screws (fig. 2-8) and lock washers

g. Through timing cover inspection hole in

and remove cover from top of engine flywheel housing.

flywheel housing install one screw (5) and lock washer

Turn engine over until timing pointer (fig.

(6) at the (decal to secure flex plate (7) to flywheel.

flywheel housing is visible through inspection hole in top

Tighten screw to a torque of 20 to 2.3 foot pounds (27.1

of flywheel housing.

to 31.1 N m).

d. Install shim (9, fig. 2-7) on front of converter.

h. Rotate flywheel and install remaining screws

and lock washers and torque as above. Install timing

Use a hoist and lift transmission into position on flywheel

cover on (fig.2-8) flywheel housing.

housing. Align timing decal on flex plate with timing

i. Install remaining screws (1) and lock washers

pointer on housing. Check marks made on flywheel and

(2) to secure transmission to flywheel housing.

flex plate during removal to see that they are aligned.

j. If engine mounts (4, fig. 2-6) were remove,

e. Pilot on converter must mate with hole in

install new mounts in holes in frame.

flywheel. Bolt heals on reinforcing plate will match

k. Install lifting eyes in engine and transmission.

clearance holes in flywheel.

Connect a chain and hoist to lifting eyes and carefully lift

f. Secure transmission

housing to flywheel

transmission and engine into place on frame in engine

housing with two screws (1) an(l lock washers (2).

compartment.

2-13