 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-630-12
Figure 4-58. Drag link and steering cylinder, removal and installation
b. Tie Rods.
(b) Inspect spring, ball seat and adjusting
(1) Adjustment. Refer to paragraph 4-74 to
plug for wear and damage.
(c) Inspect ball socket, tube and boot for
adjust tie rods for correct steering.
(2) Removal.
wear, damage and deterioration.
(d) Replace unserviceable parts.
(4) Installation.
tie rod from spindle.
(b) Raise rear of truck and block surely.
(a) Install spring (3, fig. 4-56), ball seat
Block front wheels.
(2) and adjusting plug (1) in tube (6). Do not tighten
(c) Working from under truck, remove
adjusting plug.
(b) Install tie rod on pivot arm and tighten
cotter pin (4, fig. 4-56) and loosen adjusting plug (1)
and remove tie rod from pivot arm ball stud. Remove
adjusting plug. Secure adjusting plug with cotter pin (4).
(c) Refer to paragraph 4-74 and install tie
tie rod from truck.
(3) Inspection and Repair.
rod on spindle. Adjust tie rod for proper operation (par.
4-74)
ball seat (2) and spring (3) from tie rod.
.
4-68
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals