Removal - TM-10-3930-630-120064

TM 10-3930-630-12

hydraulic reservoir drain.

(3) Draining and Refueling. At interval

specified in current lubrication order, drain and refill

(b) Remove drain plug (fig. 4-26) and

washer from bottom of reservoir (fig. 4-26) and drain

reservoir.

(a) Raise and block truck as

reservoir.

necessary. Place a suitable container beneath the

Figure 4-26. Hydraulic reservoir drain plug.

(1) Remove nuts (13, fig. 4-27) and

of oil. Refer to current lubrication order.

remove cover (14) and gasket (15).

(d) Operate hydraulic system and

(2) Flush inside of reservoir with cleaning

check for leaks. Correct if necessary.

compound solvent (P-D80). Dry interior of reservoir

(e) Bleed hydraulic system (para 4-

thoroughly.

34)

(3) Install cover (14) and new gasket (15)

c. Removal

on reservoir (12). Secure cover with nuts (13).

e. Installation.

(1) Refer to b above and drain hydraulic

reservoir.

(1) Lift reservoir into position on right side

(2) Loosen clamps and remove outlet

of frame. Secure reservoir to frame with screws (7 and

hose (fig. 4-26) from reservoir. Plug tube to pump.

8, fig. 427), lockwashers (9), and washers (10).

(3) Remove screws (7 and 8, fig. 4-27),

(2) Remove plug from tube and install

lockwashers (9) and washers (10) securing reservoir to

outlet hose (fig. 4-26) on reservoir and tube. Tighten

frame. Remove reservoir from truck.

clamps securely.

d. Cleaning.

(3) Refer to b above and fill reservoir.

4-36