Figure 4-23. Rear wheel. exploded view.

TM 10-3930-628-12

(2) Remove cotter pin (6) from wheel nut (5)

(2) Hold wheel in place and install outer wheel

and remove wheel nut and washer (4).

bearing (3), tapered side in, in wheel.

(3) Remove outer wheel bearing (3) and

(3) Refer to c above to adjust wheel bearings.

wheel assembly (2) from axle spindle.

Rotate wheels by hand. Torque wheel nuts (5) to 50

(4) Remove inner wheel bearing (1).

foot-pounds, rotating wheel six times in each direction.

Inspection. Refer to b above to inspect and

Back off nut and retorque nut to 25 footpounds. Install

clean wheel assembly. Repack wheel bearings with

cotter pin (6).

grease (GAA).

(4) Install hub cap (7) and secure with three

g. Rear Wheel Installation. Refer to figure 4-

screws (9) and lock washers (8).

23 and install rear wheels as follows:

(5) Lower jack and remove jack from truck.

(1) Install rear wheel bearing (1) on spindle,

tapered side out, and install wheel assembly (2) over

bearing.

Inner wheel bearing

Wheel and tire assembly

Outer wheel bearing

Washer

Wheel nut

Cotter pin

Hub cap

Lock washer

Screw

Figure 4-23. Rear wheel. exploded view.

4-24