 |
|||
|
|
|||
|
Page Title:
Cleaning, Inspection and Repair. |
|
||
| ||||||||||
|
|
 ME 3930-624-34/4-3
17. Bearing
1. Retaining ring
2. Capscrew
18. Bearing
3. Lock
19. Capscrew
4. Capscrew
20. Lockwasher
5. Cylinder
21. Plate
6. Seal ring
22. Seal ring
23. Retaining ring
7. Seal ring
8. Seal ring
24. Capscrew
9. Bearing
25. Lock
10. Turbine shaft
26. Cylinder
11. Piston
27. Seal ring
12. Disc
28. Seal ring
13. Spring
29. Piston
14. Pin
30. Disc
15. Retaining ring
31. Drum
16. Shaft
Figure 4-3. Drum and disc assembly, exploded view.
(c) Remove the seal rings (6, 7 and 8) and
(3) Inspect the plates for cracks, breaks and
other damage. Replace as required.
pull the bearing (9) from the turbine shaft (10).
(d) Remove the piston (11), forward drive
(4) Inspect the converter for chips, cracks,
scoring, deformation and other damage. Replace as
disc (12). springs (13) and pins (14) from the
required.
drum.
(e) Remove the retaining ring (15), shaft
(5) Inspect the pump for damage and wear. If
damage or wear is excessive, replace the complete
(16) and bearings (17 and 18).
(f) Remove the plate (21) seals (22) and
pump assembly.
(6) Replace damaged or deteriorated seals.
retaining ring (231. Remove the cylinder (26), seal
(7) Inspect the housing for cracks, chips,
rings (27 and 28), piston (29) and reverse drive
nicks, scratches and other damage. Repair or
disc (30).
c. Cleaning, Inspection and Repair.
replace as required.
(8) Inspect the spring for cracked or weak
(1) Clean all components in a suitable solvent.
condition. Replace if necessary.
Dry with compressed air.
(9) Inspect the support for cracks and other
(2) Perform general inspection procedures
damage. Replace if necessary.
4-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals