 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 h. Disassembly.
4-2. Torque Converter
(1) Torque converter. (fig. 4-2.)
a. Removal.
(a) Remove the bolts (1) and the rein-
(1) Remove the torque converter and trans-
forcing plate (2). Remove the capscrews (3), lock-
mission from the truck. Refer to paragraph 2-9.
washers (4) and the drive plate (5). Remove the
(2) Remove the attaching hardware and
converter (6).
remove the torque converter housing from the drum
and disc assembly.
ME 3930-624-34/4-2
1. Bolt
16. Lockwasher
2. Plate
17. Support
3. Capscrew
18. Preformed packing
4. Lockwasher
19. Preformed packing
5. Plate
20. Preformed packing
6. Converter
21. Snap ring
7. Bolt
22. Seal
8. Lockwasher
23. Seal
9. Pump
24. Plug
10. Preformed packing
25. Plug
11. Bolt
26. Washer
12. Lockwasher
27. Spring
13. Plate
28. Ball
14. Housing
29. Elbow
15. Bolt
Figure 4-2. Torque converter and pump assembly, exploded view.
(b) Remove the bolts (7) and lockwashers
(2) Drum and disc assembly. (fig. 4-3).
(a) Place the drum and disc assembly in an
(8) and remove the pump (9) and preformed
arbor press. Gradually apply sufficient pressure on
packing (10).
the turbine shaft (10) until the cylinder (5) is
(12) and remove the plate (13) from the converter
depressed enough to remove the retaining ring (1).
(b) Slowly release the pressure on the press
housing (14).
and remove the capscrews (2) and locks 13).
Remove the cylinder and turbine shaft as an
(16) and remove the support (17). Remove the
assembly. Tap the cylinder (5) with a soft mallet if
preformed packings (18, 19 and 20), snap ring
necessary to aid in removal. Remove the capscrews
(21) and seals (22 and 23).
(e) Remove the plugs (24) from the plate.
(4) and remove the cylinder from the turbine shaft.
Remove the plug (25). washer (26), spring (27),
ball (28) and elbow (29).
4-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals