Figure 3-15A. Tilt Cylinder, Removal and installation

TM 10-3930-611-35

Figure 3-15A. Tilt Cylinder, Removal and installation

d. Reassembly. Refer to figure 3-16 and

cracks, dents, defective seals, loose or missing

hardware or other defects.

reassemble the tilt cylinder.

e. Installation.

(3) Tighten or replace loose or missing

hardware. Replace piston rod if base metal is visible.

(1) Refer to figure 3-15 and install the tilt

Replace or rework piston rods if marks or pittings are

cylinder.

deeper than 0.015 inch.

Replace wiper rings if

(2) Install the front floor plates (TM 10-

deteriorated.

3930-611-12).

3-18