Reassembly of Tilt Cylinder

TM 10-3930-609-35

b. Remove minor surface defects from bore of

d. Position packing in stuffing box around piston

cylinder by carefully honing. Remove all traces of

and rod; then, install wiper ring in packing retainer and

abrasive after honing.

install packing retainer on stuffing box with two screws

and washers.

c. Replace all cracked or distorted parts with

serviceable parts.

Note

d. Replace wiper ring, packings, backup ring,

Tighten packing retainer screws on

piston packings and piston guide with new parts at each

moderately.

Screws can then be

reassembly.

further tightened after installation if

required to stop fluid leakage.

3-66. Reassembly of Tilt Cylinder (fig. 3-12)

e. Install rod end on piston and rod and secure with

a. Install piston guide and piston packings on

screw, nut and lockwasher.

piston and rod and carefully insert piston and rod into

cylinder.

3-67. Installation of Tilt Cylinder

b. Place spacer on piston and rod.

Refer to TM 10-3930-609-12.

c. Install backup ring and packing in groove of

stuffing box and screw stuffing box into cylinder.

Figure 3-12. Tilt cylinder, exploded view.

3-21