DISASSEMBLY - CONT - TM-10-3930-607-150157

DRIVE AXLE

Figure 5.

Figure 7.

Figure 6.

Figure 8.

3. Pry the cap (Fig. 5) from the reduction gear

hub. Pull the cotter pin, and unscrew the castellated nut

from the differential until a slight gap appears between

and washer from the stub shaft. Pull the internal gear

the flanges. Drive the axle housing back onto its studs

and outer bearing from the shaft. (Fig. 7)

and remove the 4 tapered dowels. (Fig. 9)

4. Unscrew the bolts securing the spindle to the

6. Pull the axle housing off the studs.

(Fig, 6)

axle housing. (Fig. 8) Discard damaged copper

Remove the reduction drive gear. (Fig, 10)

washers.

7. Remove the axle bearing after the re-

5. Unscrew the 8 nuts securing each axle housing

to the differential housing. With a soft hammer, drive

each

axle

housing

away

B-121