Figure 3-149. Hydraulic tilt cylinder, removal and installation.

e. Inspection.

3-75. Hydraulic Tilt Cylinder

(1) Inspect the shell assembly for cracks or

a . General. The tilt cylinder is attached between

damage.

the top of the fork carriage and the innerslide

(2) Inspect the rod for nicks and scratches.

a s s e m b l y . This cylinder is hooked up hydraulically

(3) Inspect end nut for cracks or damage.

w i t h the slave cylinder in such a way that the lift

(4) Inspect piston for scratches.

f o r k s are able to maintain the same degree of tilt

(5) Remove burrs and scratches with crocus

either raised or lowered. The tilt cylinder is used to

cloth.

tilt the lift forks.

(6) Replace a defective part.

b. Removal. Refer to figure 3-149 and remove

f. Reassembly. Refer to figure 3-150 and

the tilt cylinder.

reassemble the tilt cylinder.

c. Disassembly. Refer to figure 3-150 and

g . Test. R e f e r t o p a r a g r a p h 3 - 6 4 g a n d t e s t t h e

disassemble tilt cylinder.

tilt cylinder.

d . Repacking Cylinder. Refer to paragraph 3 - 6 4 c

h . Installation. Refer to figure 3-149 and install

for repacking procedures.

the tilt cylinder.

Figure 3-149. Hydraulic tilt cylinder, removal and installation.