Slave Cylinder

3-74. Slave C y l i n d e r

e. Inspection.

(1) Inspect shell assembly for cracks and

a. General. The slave cylinder piston rod is at-

damage.

tached to, and driven by, the boom as it moves up

(2) Inspect rod for nicks and scratches.

or down. The slave cylinder base is attached to the

(3) Inspect piston for scratches and burrs.

frame. The slave and tilt cylinder work together to

(4) Inspect end nut for cracks.

perform their particular operation. This being, as

(5) Remove burrs and scratches with crocus

f a r as possible, to maintain the same degree of

cloth.

either forward or backward tilt in the fork carriage

(6) Replace a defective part.

as the boom assembly is being raised or lowered.

f. Reassembly. Refer to figure 3-148 and

b. Removal. Refer to figure 3-147 and remove

reassemble the hydraulic slave cylinder.

the hydraulic slave cylinder.

g. Test. R e f e r t o p a r a g r a p h 3 - 6 4 g a n d t e s t

c. Disassembly. Refer to figure 3-148 and

hydraulic slave cylinder.

disassemble the hydraulic slave cylinder.

h. Installation. Refer to figure 3-147 and install

d. Repacking Cylinder. Refer to paragraph 3 - 6 4 c

hydraulic slave cylinder.

for repacking procedures.