Figure 3-66. Checking bore of cylinder liner.

Figure 3-66. Checking bore of cylinder liner.

3. Clamp the liner in place with a

(e) Fitting cylinder liner to bore in block:

1. C l e a n i n s i d e a n d o u t s i d e o f c y l i n d e r

h o l d d o w n clamp and measure distance from top of

liner. Also, clean block bore and counterbore to

t h e liner flange to top of the block. The top of the

insure proper seating. Then, slide the liner into

l i n e r flange should be 0.0465 to 0.050 inch below

block until flange on liner rests on bottom of

top of the block; and there must not be over 0.0015

inch difference between any two adjacent liners

counter bore in the block.

CAUTION

when measured along the cylinder longitudinal

c e n t e r l i n e . If above limits are not met, install liner

Do not drop or slam liner against the

in another bore and recheck, or use a new liner (fig.

bottom of counterbore in the block.

2. Tap the liner lightly with a soft

hammer to make certain the liner flange seats on

bottom of counterbore.