Disassembly of Control Housing.

TM 10-3930-242-34

Figure 3-11. Governor assembly, disassembly and reassem-

bly (sheet 1 of 2).

from shaft (8). Do not disassemble bearing since

press bearing (34) from bearing retainer support

r i s e r and bearing are serviced only as an as-

(32).

sembly.

( 3 ) Remove weight pin retainer rings (35)

f r o m governor weight pins (36) then drive pin

g . Disassembly of Control Housing.

out of carrier (9) and weights (37). Remove

(1) Remove two screws (1, fig. 3-11 ) and

weights.

washers (2) securing cover to housing (14).

NOTE

(2) Remove cover (3) and gasket (4).

Drive pins out of carrier from weight pin retainer

(3) Remove adjusting screw (5) and nut (6).

end. Punch mark the carrier at retainer end of the

( 4 ) Remove high speed spring retainer (7).

weight pins to insure pins are place in proper posi-

(5) Remove high speed spring (8) shims (9)

tion when reinstalling weights in carrier.

and plunger (10).

( 6 ) Remove low speed spring cap (11), low

( 4 ) Slide riser (38) and bearing assembly