|
|
TM10-3930-242-12
in place and use cotter pin and pinto reconnect them
to the correct control linkage.
(2) Throttle Pedal.
attach pedal to mounting plate and cockpit floor.
(b) Use cotter pin and pin to connect throttle
pedal to the control linkage.
Section XII. MAINTENANCE OF TRANSMISSION
4-53. General
b. Cleaning and Inspection.
(1) Clean the filter head with an approved
This section contains information for organizational
cleaning solvent and dry thoroughly. Make sure old
maintenance of the transmission.
gasket material is removed, and install a new filter
element and gasket.
(2) Inspect the new filter for cracks, breaks, and
a Removal.
loose connections. Check the oil for contamination.
(1) Remove the forward panel under the right
rear fender.
c. Installation.
(2) Refer to figure 4-34 and remove the trans-
(1) Refer to figure 4-34 and install the trans-
mission external filter.
mission external filter.
NOTE
(2) Service transmission in accordance with
current lubrication order.
Change filter element at every trans-
mission oil change. The filter element is a
throw away type paper element.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |