Starting - TM-10-3930-242-120019

TM 10-3930-242-12

b. Starting. Refer to figure 2-2 and start the

2-3. Starting

forklift.

a Preparation for Starting. Perform the before

CAUTION

operation services in table 3-1.

Continue operation only if there is not an

NOTE

apparent loss of hydraulic oil or no

Starting circuit is operative only when

unusual noise from the hydraulic pump to

FWD NEUT REV control lever is in

prevent damage to the forklift.

NEUT.

PLACE FWD-NEUT-REV LEVER IN NEUT POSITION.

STEP

ENGAGE PARKING BRAKE.

STEP

CHECK RADIATOR FAN CONTROL LEVER FOR PROPER POSITION.

STEP

PLACE IGNITION SWITCH IN ON POSITION.

STEP

PRESS ACCELERATOR PEDAL DOWN ONE THIRD DISTANCE.

STEP

PRESS STARTER BUTTON.

STEP

WARM ENGINE FOR THREE TO FIVE MINUTES AND OBSERVE INSTRUMENTS FOR

STEP

NORMAL READING (FIG. 2-1).

REMOVE FOOT FROM ACCELERATOR PEDAL.

STEP 8:

TA072307

Figure 2-2. Engine starting instructions.

2-3