 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 (5) Remove hub from spindle.
hammer. Tap evenly around edge of
cup. Use care to prevent cup from
(6) Remove grease shield and inner bear-
binding.
ing cone.
(7) Tap out bearing cups from hub using
(2)
Install the bearing cones and wheel or
a brass drift positioned in hub slots.
hub assemblies in reverse order of re-
moval. Hold the wheel assemblies in
f. Steering Wheel Installation. Reverse pro-
position while installing outer bear-
cedures in d or e above. Install and adjust
ings.
wheel bearings as instructed in h below.
(3)
Install key washer, lock plate, and
g. Cleaning and Inspection. Using SD, wash
bearing nut.
all grease from the bearing surfaces and inside
Tighten the bearing nut and at the
(4)
bore of wheel hub. Inspect bearing cones and
same time, rotate the wheel until a
cups for excessive wear or scoring. Repack
heavy drag is felt. Loosen the nut to
bearings (fig. 1).
a point where the wheel rotates freely
but with no apparent bearing end
h. Installation and Adjustment.
play.
(1) Install bearing cups with the taper to
(5)
Bend ears of lock plate against side of
the outside of the wheel or hub. Tap
nut flats. Install hubcap.
into place using a brass drift and
AGO 6217A
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals