 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 (4) Remove distributor and spark plug
cables (para. 40b) and distributor
drive shaft.
(5) Remove ignition coil.
(6) Remove nuts and washers then lift
engine wire harness clips off of studs.
(7) Disconnect temperature sending unit
wire, then remove sending unit.
(8) Remove nuts and washers, then re-
move cylinder head and gasket.
b. Cleaning and Inspection.
Clean all carbon from cylinder head,
block, and top of pistons using a
carbon scraper and wire brush.
Clean the cylinder head thoroughly
with SD.
Inspect head and block for cracks or
excessive erosion of water passages.
Make sure that gasket surfaces are
clean, smooth, and flat.
AGO 6217A
19
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals