 |
|||
|
|
|||
|
Page Title:
Figure 20. Carburetor, exploded view |
|
||
| ||||||||||
|
|
 (8)
Remove bearing sleeve (8) and oil
seal (9) from body.
(9) Remove drive shaft bushing (33)
from body.
(10) Remove drive shaft thrust plate (34)
from body.
c.
Cleaning. Clean all parts in SD and wipe
dry with clean cloth.
d.
Inspection and Repair.
(1) Inspect all parts for wear or damage.
(2) Replace
defective
parts
as
authorized.
e.
Assembly. Reverse procedures in b above.
f.
Installation and Adjustment. Refer to TM
10-3930-222-20.
1
Head, filter
2
Washer, filter head
3
Filter, element
4
Washer, valve seat
5
Seat, valve
6
Valve
7
Float
8
Gasket
9
Valve, power, jet
10
Jet, main
11
Washer, nonmetallic
12
Jet, main discharge
13
Washer, passage plug
14
Plug, discharge jet passage
Figure 20. Carburetor, exploded view
15
Plate, throttle
16
Body, throttle
(2)
Remove clip (19) from end of gear
17
Needle, idle adjusting
and shaft base assembly and remove
18
Gasket, flange
two washers (20 and 21), fork base
19
Lever, and shaft, throttle
20
Screws, throttle plate
(22), thrust bearing (23), upper race
21
Gasket, bowl-to-body
(24), and four balls (25) from drive
22
Venturi
shaft.
23
Bowl, fuel
(3)
Loosen locknut (6) on adjusting screw
24
Screw, bowl-to-body
(5). Unscrew adjusting screw and
25
Jet, well vent
remove from body.
26
Jet, idle
(4)
Remove pipe plug (37) from governor
27
Axle, float
body to gain access to fork pin
28
Cylinder, vacuum
(30)and remove fork pin from lever
29
Washer, vacuum cylinder
shaft (13).
30
Intake, air
(5)
Slide lever assembly (13) from body
31
Lever and shaft, choke
32
Screw, bracket assembly]
(7). As lever is removed from body,
33
Bracket, choke
fork (31) and bumper springs (32) will
34
Screw, intake
fall from body.
35
Screw, choke plate
(6)
Separate fork and bumper spring.
36
Plate, choke
(7)
Drive expansion plug (36) from body
Figure 20 - Continued
and remove bearing (35).
AGO 7010A
30
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals