CHAPTER 2 MAINTENANCE INSTRUCTIONS

CHAPTER 2

MAINTENANCE INSTRUCTIONS

Section I. TOOLS AND EQUIPMENT

8. Repair Parts end Special Tools

9. Common Tools

The common tools that are used in held

The repair part and special tools that are authorized

maintenance (third and fourth echelon) and depot

for use in field maintenance (third and fourth echelon)

maintenance (fifth echelon) of this truck are authorized

and depot maintenance (fifth echelon) of this truck are

in the appropriate table of allowance.

listed and illustrated in TM 10-3930-222-35P

Section II. TROUBLESHOOTIN6

transmission and torque converter is needed, refer to

10. General

TM 10-3980-90.

This section contains troubleshooting information in

chart form for aid in locating and correcting some of the

11. Procedures

common troubles which may develop in the

Troubles and troubleshooting procedures in chart form

transmission and torque converter.

If a specific

are shown in figure 1. Read the chart from left to right.

malfunction or the troubleshooting instruction is not

The troubles are listed in the first block. Follow the

covered herein, isolate the system in which the trouble

directions in the succeeding blocks until the defects are

occurs and locate the defective component. When

located.

troubleshooting information on systems other than the