Inspection and Repair - TM-10-3930-634-340117

TM 10-3930-634-34

(7) Remove thecylinder liner seal ring from the

groove in the cylinder block bore.

NOTE

All cylinder liners are removed in the same

manner.

c. Cleaning. Clean the cylinder liner with cleaning

solvent P-D-680 and dry thoroughly.

d. Inspection and Repair.

(1) Refer to figure 3-142 and thoroughly inspect

the cylinder liner out of round condition, taper, cracks,

scoring, flange irregularities and erosion.

(2) Refer to table 1-1 for liner dimensions and

measure the liner at points shown in figure 3-142. Top

check these dimensions, use a dial bore gage which has

a dial indicator calibrated in 0.0001 inch increments