Figure 4-84. Transmission control adjustment.

TM 10-3930-630-12

(c) If engine starts, transmission selector

switch has not closed starting circuit.

(d) Remove cotter pin and pin and detach

valve is in neutral position. If engine does not start,

selector valve is not in neutral position and neutral start

yoke (Fig. 4-84) from transmission selector valve.

Figure 4-84. Transmission control adjustment.

CAUTION

(e) Move selector valve back and forth to

determine center, or neutral, position. Again at-tempt to

Do not thread yoke to far on shift rod. End

start engine. If engine starts, transmission is in neutral

of shift rod must not protrude through yoke

(f) Hold selector valve in this position and

and come out on other side. If it does,

selector valve movement will be restricted.

loosen nut on shift rod (Fig. 4-84) to move yoke on rod

to lengthen or shorten rod to aline with selector valve in

(g) Connect yoke to selector valve

neutral position. Tighten nut to secure yoke.

plunger with pin and cotter pin.

(h) Operate truck and check adjustment.

4-91