Control Lever and Linkage

TM 10-3930-630-12

1 Tywrap

11 Screw

2 Hose

12 Lockwasher

3 Elbow

13 Filter

4 Clamp

14 Base

5 Hoe

15 Screw

6 Elbow

16 Washer

7 Fitting

17 Lockwasher

8 Hose

18 Nut

9 Elbow

19 Bracket

10 Elbow

Figure 4-83. Transmission oil filter and hoses, exploded view.

4-99. Control Lever and Linkage

(3) If hoses require replacement disconnect

a. General The transmission is controlled through

hoses, remove clamps or tywrap and remove elbows

and fittings as necessary. Plug hoses and openings to

a linkage extending from the bottom of the control

prevent entrance of foreign material

column. A lever at the end of the column is connected

d. Installation.

to the transmission forward and reverse plunger with a

(1) If hoses were disconnected or fittings were

shift rod and yoke. The inching pedal operates the

removed, remove plugs and install fittings and connect

inching valve through a pin and screw attached to the

hoses.

Secure hoses with tywrap or clamp as

valve plunger.

b. Adjustment

necessary.

(2) Apply a light coat of transmission oil to

(1) Shift Rod.

(a) Remove floor and toe plates.

rubber gasket on filter. Screw filter (13, Fig. 483) into

(b) With the engine off, place forward and

base by hand and hand tighten only.

(3) Close left side panel.

reverse control lever in N (neutral) position. Attempt to

(4) Refer to paragraph 4-12 and add oil to

start truck engine.

transmission, if necessary.

4-90