Figure 33. Planetary carriage assembly, installed on transmission.

Figure 33.

Planetary carriage assembly, installed on transmission.

(13) Remove remaining friction disk (18) and

(6) Remove top separator plate (26) from top of

separator plates (16) alternately from clutch

spring.

assembly.

(7) Remove clutch springs (27) from clutch

(14) Remove outer springs (17) from disk ring (14).

assembly.

(15) Remove clutch ring (14) from clutch assembly.

(8) After removing top separator plate from

(16) Remove high gear clutch shaft assembly (13)

assembly, remove friction disks (31) and

from clutch assembly.

separator plates (26) alternately.

(17) Remove bearing (12) from rear end housing (8).

(9) Remove disk ring (28) from clutch assembly.

(18) Separate high-and-low clutch hub (5) from rear

(10) Remove separator plate (16) from clutch

end housing (8).

assembly.

(19) Remove clutch piston (11) from rear end

(11) Remove hub assembly (29) from clutch

assembly.

housing (8) by turning housing over and gently

tapping the edges so the piston will fall out.

(12) Remove thrust washer (30) from clutch hub

(13).

GO 7010A