 |
|||
|
|
|||
|
Page Title:
Figure 32. Planetary carriage assembly, exploded view. |
|
||
| ||||||||||
|
|
 1
Washer, thrust, planetary carriage
16
Seal, oil, ring gear hub
2
Gear assembly, planet, carriage, drive
17
Capscrew
8
Cage assembly, planet
18
Lockwasher
4
Washer, thrust
19
Retainer, front
5
Shafts, pinion
20
Packing, preformed
6
Pinion set, planet 18-tooth
21
Shim, front retainer
7
Pinion set, planet 19-tooth
22
Ring, snap
8
Washer, thrust
23
Capscrew
9
Washer, thrust, sun gear
24
Lockwasher
10
Gear, sun, drive
25
Cover, front
11
Washer, thrust, sun gear
26
Shim, front rover
12
Cover, cage assembly planet
27
Packing, preformed
13
Plate, retainer
28
Ring snap
14
Bolt place
29
Bearing
15
Washer, thrust, sun gear
30
Gear assembly, ring
Figure 32. Planetary carriage assembly, exploded view.
(23) Install forward drive gear on gear assembly (fig.
b. Disassembly.
(1) Remove snap ring (1, fig. 56) and remove
(24) Install bearing on forward drive shaft assembly
housing cover from clutch assembly.
(2) Remove two seal rings (3 and 4) from front of
(25) Install ring retainer on forward drive shaft
clutch assembly.
assembly.
(3) Remove ring seals (19 and 20) from housing
(26) Install two ring seals (fig. 55) on forward drive
assembly (22).
shaft assembly.
(4) Remove thru screws (21) from clutch assembly.
(27) Install two ring seals on clutch end housing.
Caution: The clutch assembly will fail
e. Installation. Reverse procedures in a above.
apart when removing the thru screws (21)
due to spring tension inside the pack, if care
42. High-and-Low Clutch Assembly
is not exercised in removing through
a. Removal.
screws.
(1) Remove transmission (par. 38a).
(5) Remove housing assembly (22) from clutch
(2) Remove high-and-low clutch assembly by
assembly.
following steps (1) through (7) in paragraph 38b.
AGO 7010A
46
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals