WEAR PADS REPLACEMENT - continued - TM-10-3930-673-340678

TM 10-3930-673-34

16-16. WEAR PADS REPLACEMENT (CONT)

c. Inspection. See Inspection Instructions (Para 2-14).

d. Installation.

(1)

Install wear pad(s).

(a)

Install inserts (4) in wear pads.

WARNING

Adhesives, solvents, and sealing

compounds can burn easily, can give

off harmful vapors, and are harmful

to skin and clothing. To avoid injury

or death, keep away from open fire

and use in a well-ventilated area. If

adhesive, solvent, or sealing

compound gets on skin or clothing,

wash immediately with soap and

water.

(b)

Apply sealing compound on threads

of screws (1). Install shims, spacers,

wear pads, washers (3),

TR01023

lockwashers (2), and screws (1).

Tighten screws to 30 lb-ft

(40.67 Nm).

NOTE

Check for proper clearances between wear pads and boom sections during assembly. A

total gap of 0.01 - 0.13 in. (0.25 - 3.30 mm) is allowed in both vertical and horizontal

directions.

(2)

Assemble inner and intermediate booms as necessary (Para 16-12) and

END OF TASK

16-92