REAR PLANETARY WHEEL ENDS REPLACEMENT - continued

TM 10-3930-673-34

9-6. REAR PLANETARY WHEEL ENDS REPLACEMENT (CONT)

(6)

Assemble planetary spider (1) parts

(5 through 8).

(a)

Apply a thin film of gear lubricating

oil to bore of planetary gear (8).

Slide planetary gear and washer (7)

onto planetary pinion shaft (6).

WARNING

Use care when installing snap and

retaining rings. Snap and retaining

rings are under spring tension and

can act as projectiles when released

and could cause severe eye injury.

TR00717

(b)

Install snap ring (5) onto planetary

pinion shaft (6).

(c)

Repeat Steps (a) and (b) for second and third sets of planetary gears (8), washers (7), and snap

rings (5).

(7)

Install planetary gear assemblies.

(a)

Remove dirt, grease, or moisture from the mating surfaces of planetary spider (1) flange and

wheel hub (2) mounting face.

(b)

Dry both surfaces.

WARNING

Adequate ventilation should be provided when silicone RTV-732 clear sealing compound

is applied in confined areas. Failure to do so could cause respiratory irritation,

headaches and nausea. Eye contact with silicone RTV-732 clear sealing compound may

cause irritation; if eye contact takes place, flush eyes with water for 15 minutes and have

eyes examined by a doctor.

(c)

Apply a continuous bead of silicone RTV-732 clear sealing compound approximately 1/8 in.

(3.175 mm) in diameter completely around the hub mounting face and around the inner edge

of all fastener holes to assure complete sealing and prevent leakage.

NOTE

Assemble components immediately to permit silicone RTV-732 clear sealing compound to

spread evenly. Failure to do so could cause axle to leak.

(d)

Start planetary spider (1) onto wheel hub (2), aligning teeth of planetary gears (8) with sun

gear (9) and ring gear (10) teeth.

9-40