 |
|||
|
|
|||
|
Page Title:
REAR PLANETARY WHEEL ENDS REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 10-3930-673-34
(5)
Install planetary ring gear (10) and
sun gear (9) on wheel hub (2).
(a)
Install dowel pin (16) in nut (15).
(b)
Locate hole (A) on back of planetary
ring gear (10). Orient ring gear with
respect to dowel pin (16) on nut (15).
NOTE
If pin is not aligned with hole (A)
of ring gear, spider assembly will
not fit tight to wheel hub.
It may be necessary to turn nut (15) to
match hole (A) on back of planetary
ring gear. Hub bearing nut may be
tightened to match dowel pin (16) with
planetary ring gear, but torque on hub
bearing nut should not exceed 150 lb-ft
(203.37 Nm).
(c)
Install planetary ring gear (10).
WARNING
TR00462
Use care when installing snap and
retaining rings. Snap and retaining
rings are under spring tension and
can act as projectiles when released
and could cause severe eye injury.
(d)
Install washer (13), sun gear (9),
and snap ring (11). Tangs on washer
must engage slots in ring
gear (10).
TR00463
9-39
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals