REAR PLANETARY WHEEL ENDS REPLACEMENT - continued

TM 10-3930-673-34

9-6. REAR PLANETARY WHEEL ENDS REPLACEMENT (CONT)

c. Inspection. See Inspection Instructions (Para 2-14).

d. Installation.

(1)

Assemble spindle (12) parts (21

through 25).

(a)

If removed, install bushing (24) into

wheel bearing spindle (12) until top

of bushing is flush or just below

bottom of bore for seal (25).

(b)

Install oil seal (25) to bottom of

spindle bearing spindle (12) bore.

(2)

Install wheel bearing spindle (12)

parts (21 through 25).

TR00459

(a)

Apply a thin film of gear lubricating

oil to lips of oil seal (25) and bore of

bushing (24) in wheel bearing spindle (12) bore, and oil seal journal on axle shaft short end.

CAUTION

Inner oil seal and bushing in bore of spindle could be damaged when sliding spindle past

axle splines. Install spindle carefully to avoid damaging bushing inner oil seal. Failure to

do so could cause premature component failure.

(b)

Install wheel bearing spindle (12).

NOTE

Install two shorter screws at two top holes and two screws at bottom two holes on wheel

bearing spindle flange.

(c)

Install 10 screws (21), four screws (22), and 14 washers (23) on wheel bearing spindle (12).

Tighten screws (21 and 22) to 150 lb-ft (203.37 Nm).

9-36