FRONT DIFFERENTIAL CARRIER ASSEMBLY REPLACEMENT/REPAIR/ADJUSTMENT - continued

TM 10-3930-673-34

WARNING

Adhesives, solvents, and sealing

compounds can burn easily, can give

off harmful vapors, and are harmful

to skin and clothing. To avoid injury

or death, keep away from open fire

and use in a well-ventilated area. If

adhesive, solvent, or sealing

compound gets on skin or clothing,

wash immediately with soap and

water.

(n)

Apply sealing compound to threads

of screws (23). Install four of the

eight screws and four washers (24)

as opposing pairs (X and Y) into case

halves (25 and 26).

TR00267

CAUTION

Spacing between four initially installed screws must be even to prevent uneven pressure

on case halves when torquing. Failure to do so could cause component failure.

(o)

Torque four screws (23) to between 60 - 75 lb-ft (81.35 - 101.69 Nm).

NOTE

Tighten screws in pairs on opposing sides of ring gear.

(p)

Install remaining four screws (23) and four washers (24). Tighten screws to between 60 -

75 lb-ft (81.35 - 101.69 Nm).

(q)

Remove no-spin retaining bolt,

washers, and wing nut.

TR00276

8-23