TRANSMISSION FRONT COVER REPLACEMENT/REPAIR - continued

TM 10-3930-673-34

7-5. TRANSMISSION FRONT COVER REPLACEMENT/REPAIR (CONT)

(4)

Install parts (14 through 22).

WARNING

Adhesives, solvents, and sealing

compounds can burn easily, can give off

harmful vapors, and are harmful to skin

and clothing. To avoid injury or death,

keep away from open fire and use in a

well-ventilated area. If adhesive, solvent,

or sealing compound gets on skin or

clothing, wash immediately with soap and

water.

TR00235

(a)

Apply sealing compound to converter

pressure relief valve (22) and drive into

bore until valve seat shoulders against

bottom of bore.

(b)

Apply sealing compound to threads of Allen head pipe plug (21) and install Allen head pipe plug to back

side of front cover (1).

(c)

Install stator support tube (20), cover plate (19), and six screws (18) on front cover (1).

(d)

Install transmission input shaft (17), as an assembly through back of front cover (1). Ensure that flat side of

bearing retainer (A) is against front cover (1).

(e)

Apply sealing compound to threads of three screws (16) and install in input shaft (17) and front cover (1).

(f)

Install thrust washer (15) against cover plate (19).

(g)

Install impeller gear (14) against thrust washer (15).

(5)

Install parts (9 and 11 through 13) and

bearing retainer (10) on front cover (1).

WARNING

Use care when installing snap and

retaining rings. Snap and retaining rings

are under spring tension and can act as

projectiles when released and could cause

severe eye injury.

(a)

Install bearing (13) with retaining ring

(12) on bearing retainer (10).

TR00231

7-48